Our first batch release for the new XT Brushless Motor.  These are essentially pre-production and will give you an idea of what to expect in the final version, next batch will see a price increase.  They come with a 1 year warranty (restrictions apply *). 

There is a small button on the motor cap that controls the speed, there is only 2 speeds (be careful when pushing, be gentle).  This is with a standard 11.1v 15-25C battery.  The default = 34K and the slow = 30K.  In order to switch between the 2, depress the botton using a bit of wire (paper clip works fine) and pull the trigger.  You will hear some beeps, this will put the motor into either fast or slow mode.  Ideally these motors work best with 11.1v batteries.

Features:
- D type MIM Steel pinion
- CNC aluminium body
- UH grade (38UH) high performance NdFeB magnet
- Dual motor tower bearing
- Dual speed control
- Enlarged width motor tower (9.45mm)

Motor Grip Modification
- On non-standard motor grips you may need to modify the bottom grip plate.  So far this has been reported on the following grips:
PTS / Magpul style (EPG etc)
ICS PSW
G&G ARP9

IMPORTANT
1. Do not power the motor with the cables reversed.  Always check this.
2. Do not use any Active Breaking.  ROF control and Pre-cock seems to be ok but if you do use it monitor.
3. As with all motors if you get a gearbox lock-up, don't keep your finger on the trigger trigger.  Use common sense.
4. If changing the pinion yourself do not force it on, do not whack with a hammer! Too much force will damage the rear bearing causing performance issues.